Filter
Top Products
106 en | Control Center Digital Video Recorder
F01U | 2.0 | 2008.12 User Manual Bosch Security Systems
• NTP: Mark up when using the NTP (Network Time Protocol) server for time adjustment.
• Date format: Select the date display format.
• Time zone: This option setting is not available in the Control Center program.
• Server: Select your time server.
The DVR will obtain the average time among 5 public servers (time.nist.gov, time-a.nist.gov,
time-b.nist.gov, ntp.nasa.gov, clock.isc.org).
• Private time server: Enter the private time server’s IP address or host name.
• Sync. interval: You can set synchronized interval with the NTP time server to 1 day, 1 hour, 1
week and 1 month.
• Daylight saving: Mark up when you use the daylight saving function.
- Start: Select the Daylight Saving start time.
- End: Select the Daylight Saving end time.
Hard Disk
• Overwrite: Select the overwrite recording type (Off, Normal partition, Event partition or All).
This function is possible when the selected HDD type has fully recorded.
• Disk full warning: When the HDD has overfl owed the warning message is displayed.
• Event partition: Sets the space of event partitions for event recording.
Log Out
• Auto user logout: Setting the logout time. You can set the auto logout time to 5 minutes, 10
minutes, 30 minutes or 60 minutes.
Sound settings
Select the beeper options.
• Button beeper: Makes a sound when using the buttons.
• Input beeper: Makes a sound when an input occurs.
• Motion beeper: Makes a sound when motion is detected.
• System beeper: Makes a sound when a cooling fan is not activated or the HDD has bad sector.
Update settings
Set the update options.
• Item Selection: Select the items for updating.
- PTZ Protocol: Set to PTZ Protocol update.
- System fi rmware: Set to System software update.
• Method: Select the update method.
- USB: Update from USB memory stick.
- Network: Update from the update server.
• Update server: Enter the IP address of the update server.
Note:
If you can not update from the update server, check the TCP/IP options and
the IP address of the update server.