Filter
Top Products
11
Displaying a TV signal
NOTE: If needed, you can pur-
chase longer cables at your local
electronics store.
Determine the cables you’ll need (refer to the table on page 10 if
necessary). This depends on what type of output is coming from
the tuner (remember, you cannot directly connect the coaxial
cable that enters your house from a cable or satellite company,
the signal must pass through a tuner first.) Also, determine if you
want the sound to come out of the projector or out of your own
audio system. You can connect the audio directly to the projector
to get sound from the 3-watt onboard speaker, or you can con-
nect it to your stereo’s receiver to get sound from your own
speakers.
If your TV tuner has S-video output:
1 Plug one end of the S-video cable to the “S-video out” connec-
tor on your tuner (Figure 12). This connector may be labeled
“To Monitor.”
2 Plug the other end of the cable into the S-video connector
(labeled video 1) on the projector.
F
IGURE
12
Connecting the projector to a TV tuner using the S-video cable
3 If you want sound from the projector’s speaker, plug the A/V
cable’s white connector into the left “audio out” connector on
your video device. Plug the cable’s red connector into the
right “audio out” connector on the video device (Figure 13).
4 Plug the A/V cable’s other white connector into the white
“audio L” connector on the projector. Plug the cable’s other
red connector into the red “audio R” connector on the projec-
tor. The yellow connectors on the A/V cable remain unused.
S-video
cable