Filter
Top Products
13
8 Turn on your TV tuner.
•
The TV image should display on the projection screen. If it
doesn’t, press the
source
button on the keypad or the
video
button on the remote to display your TV image (press the
button until “S-video” appears in the corner). You can
select a default source to determine which source the pro-
jector examines first during power-up for active video; see
“Default Source” on page 45.
•
If necessary, adjust the height of the projector. See page 28.
•
If necessary, adjust the zoom or focus of the image by turn-
ing the rings around the lens. See page 27.
•
If you are projecting on a 4:3 screen, change the screen
aspect to 4:3. See page 35.
•
If necessary, make adjustments to the image using the pro-
jector’s on-screen menus. To open the menus, press the
menu/select
button on the keypad or remote, then select the
Display or Image sub-menu. For more information about
the menus, see page 33.
•
If the image is not square, use the keystone buttons on the
remote to adjust the image’s shape. See page 31.
•
If you connected the audio cables to the projector, use the
volume
buttons on the keypad to adjust the volume. If you
connected the audio cables from your tuner to your
receiver, use the receiver’s volume control.
The projector is compatible with these major broadcast video
standards: NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, PAL-60, and
SECAM. It automatically adjusts to optimize its performance for
the incoming video. The input signals for SECAM, PAL-M, PAL-
N, andPAL 60 video are similar to other video signals and cannot
be automatically detected, therefore they must be chosen manu-
ally. See page 41.