Filter
Top Products
22
Setting up the Projector
Turning Off the Projector
If you want to turn off the projector for a short period of time,
press the
standby
button on the keypad or remote. This blanks the
screen for fifteen minutes, but keeps the projector running. (You
can change the amount of time the projector stays in standby
mode; see page 45 for details.) After 15 minutes, the lamp goes
out. To exit standby mode, press the
standby
button again. (It may
take several seconds for the projection lamp to reach full power
and project the image again.) See page 32 for details on standby
mode.
NOTE: Lamp life will be extended
if you turn the power off, then wait
1 minute while the lamp cools
before unplugging the projector.
The Lamp LED will light green
when the lamp has cooled.
To turn off the projector, press the
power
button (you can cancel
the shutdown by pressing the
power
button again within 10 sec-
onds). The lamp turns off and the LED blinks amber for a minute
while the fans continue to run to cool the lamp. When the lamp
has cooled, the LED lights green and the fans stop. Unplug the
power cord to completely power off the projector.