Filter
Top Products
User Manual for Commercial Series Net DVR
Page 67 Total 121
The whole screen is divided into 22*18 panes (NTSC: 22*15). There is one yellow panel on
the upper left side. The motion area setup steps are the same as that of mask area setup (refer to
chapter 5.7). The only differences are that you can use【PTZ】key to set the whole screen as motion
area, and multiple motion areas can be defined. Press【A】key to clear all motion areas.
Setup multi areas: After you setup one motion area, press【EDIT】key, the yellow pane will
appear again, then you can setup another motion area.
Clear motion area:
Clear part of motion area: Move the yellow pane to the start clear position of motion area,
press【EDIT】, you will find the yellow pane is turned into black pane. You can use【↓】【→】keys
to enlarge or shrink the black area. Press【EDIT】key to clear this part motion area.
Press【Enter】key to save and return to “Image” menu. Press【ESC】to cancel.
Clear all motion areas: Press【A】key to clear all motion areas of this channel.
The keys used to setup motion areas are as follows:
l 【↑】【↓】【←】【→】: Move yellow panel to any position;
l 【EDIT】:Yellow panel and red panel switch key:;
l 【→】: Right-enlarge red panel;
l 【←】: Left-shrink red panel;