Filter
Top Products
User Manual for Commercial Series Net DVR
Page 76 Total 121
and the other is “Handle”. If you select “Handle” option, you can activate “Policy” and “PTZ
Linkage” buttons on right side. Move “Active Frame” to “Policy” button and press【ENTER】key,
you will enter into “Alarm in Handling” sub menu:
Step 4: Alarm trigger record channel setup
You can select channels to record for each alarm input. In the sub menu, you can use
【ENTER】or【EDIT】key to enable record channel. “×” means disable and “ü means enable.
Note: In order to trigger the channel to record, in “Recording” menu, you must enable
recording and select record type as “Alarm” or other related type. Please refer to chapter 5.12.
Step 5: Schedule for alarm handle method
When an external alarm occurs in the schedule, the DVR will respond according to the
handle methods.
Step 6: Alarm handle method
You can select one or more handle methods: “On Screen Warning”, “Audible Warning”,
“Upload to Center” and “Trigger Alarm Output”.
Description: If “On Screen Warning” is enabled, when an external alarm happens and DVR is
in preview mode, DVR will display the related camera. If you trigger more than one camera, DVR
will display them one by one every 10 seconds. When the external alarm ends, the DVR will
return to preview mode.
Step 7: Save setup
In “Alarm in Handling” sub menu, press “Confirm” button and return to “Alarms” menu. In
“Alarms” menu, press “Confirm” button to save the parameters.
Step 8: PTZ Linkage