Dish Network Duo 322 Satellite TV System User Manual


 
Page 55
Control Other Devices with the Remote
Page 55
Scan for Device Codes
If the code for your device is not listed in the tables in Chapter 4, use this
procedure to scan the remote control’s memory for the device code.
9. Turn the device back on and
try some other buttons to
make sure they work. If the
code works for other buttons,
stop here.
Sometimes the POWER button
works when other buttons don’t.
10. If the code doesn’t work, redo
steps 3 through 8 with another
device code from the tables.
Try every code listed for your brand
until one works for your device.
11. If you can’t find a code that
works try Scan for Device
Codes below.
1. Turn the device on. Use the device’s front panel buttons
or its remote control.
2. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light will flash.
3. For AUX mode only. Press 0
for a second TV, or 1 for a
VCR or DVD player, or 2 for
a tuner, or amplifier. Press the
STAR (*) button.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you’re not programming in AUX
mode, skip to step 4.
4. Press the POWER button. This puts your remote in the scan
mode.
5. Press the either the UP or
DOWN ARROW button
repeatedly until the device
turns off.
As you press the UP or DOWN
ARROW button, the remote is
trying each code in the memory to
see if it can turn off your device.
When the device turns off, you have
found a code that might work.
Note
: The mode button for the
device will flash rapidly eight times
when you’ve scanned all the codes
for that device.
6. Press the POUND (#) button. This stores the code you found.