Dish Network Duo 322 Satellite TV System User Manual


 
Page 61
Testing the System
Page 61
Testing the System
Starting a Test
1. Press the MENU button.
2. Select the
System Setup option.
3. Select the Diagnostics option.
Telephone Connection Test
This test checks that the receiver telephone connection is correct. Select the
Connection option to begin the test. The receiver displays a message asking
you to wait until the test is done.
If the telephone connection is correct, the receiver displays a
Phone
Connection OK message.
Select the Dial Out option so the receiver can make a toll-free call to the
Customer Service Center. Press the SELECT button to start the call. When
the call is done, select the
Cancel option to exit the test menu.
If the telephone line is not connected properly, the receiver displays a
failure message. Check the telephone connection and then repeat the test.
Note: If you have the receiver connected to a DSL (Digital Subscriber
Line) phone line, it may cause this test to fail. If so, you will need to install
a DSL filter between the receiver and the phone jack on the wall. You can
get a DSL filter from your Internet Service Provider or a local electronics
parts store.