Filter
Top Products
Page 21
Connecting the Receiver to the TV(s) in Another Room(s)
Connecting the Receiver to the TV(s) in Another
Room(s)
This section describes how to connect the receiver CH 21–69 OUT
connection to the cable-ready remote TV located in another room away
from the receiver. This installation uses your in-home cable system. If your
house does not have built-in cabling, it will be necessary to run cables from
the receiver to each remote TV. Due to the difficulty of this installation, you
should consider having this professionally installed. Call DISH Network at
1-800-333-DISH (3474).
Note: When connecting to the home distribution (CH 21–69 OUT) coaxial
port, you must meet the FCC requirements in the Appendix. To meet these
requirements, an in-line coaxial attenuator has been included with your
receiver and may need to be installed using the following guidance:
• If connecting to your in-home cabling system to distribute the signal to
a TV(s) in other rooms, in most cases you will not have to install the
attenuator on the
CH 21–69 port for typical in-home cabling systems.
• If connecting directly to a TV tuner port, you must install the attenuator
in the cable between the
CH 21–69 OUT port and the TV tuner.
If you have an off-air antenna or cable connected to your in-
home cable system, see Optional - Connecting to an Off-
Air Antenna or Cable following this section.
Attenuator
Receiver Back Panel