Filter
Top Products
Chapter 2
Page 34
Receiver Description and Installation
3. Put the UHF antenna onto the attenuator.
Setting Up TV1 to Operate in UHF Pro
You can set your receiver to operate your TV1 using another UHF Pro
remote control (sold separately) by completing the following instructions:
1. Perform the following using an existing remote control:
a. Open the
TV1 UHF Pro Setup screen by pressing MENU-6-1-8 on
the remote control.
b. Select
Enable from the TV1 UHF Pro Setup screen.
c. Select
System Info to open the System Information screen.
d. Move the highlight to the address for the
Primary Remote Address
as shown below. This is important - if you do not do this, your
remote will change the receiver's
Secondary Remote Address and
cause your Remote Control 1 to control the
side of your receiver.
2. Perform the following using the UHF Pro remote that you are going to
use to control TV1:
a. Press and hold the SAT mode button about three seconds, until all
the mode buttons light up, and then let go of the SAT button. The
SAT mode button will blink.
b. Use the NUMBER PAD buttons to enter any number from 1 to 16,
except for the number shown by the
Secondary Remote Address.
The SAT mode button goes out after you enter each digit, and then
lights up again.
Write down the number you entered:
If you set up your DISH 322 to operate the side using UHF Pro,
the two UHF Pro remotes for this receiver will interfere with
each other when operated at the same time. This may prevent
the remotes from operating the receiver momentarily.
Note: Highlight the
Primary Remote
Address.