Filter
Top Products
Page 27
Connecting the Receiver to the Phone Line
4. For TV2 Out, select either Air (for off-air channel numbers) or Cable
(for cable channel numbers).
5. Highlight the number under
TV2 Out.
6. Use the UP and DOWN ARROW buttons to change the modulator
channel to one of the following:
•
Air Mode - Select a channel between 21 and 69.
•
Cable Mode - Select a channel between 73 and 125.
7. Select
Done to save the changes.
8. Change the channel on your TV(s) to match the channel(s) you selected.
9. If desired to remind you of which TV channel to tune to get satellite
programming, place a channel sticker near or on your TV to indicate the
correct channel.
10. If you changed your TV2 Out channel, repeat Programming the
Recover Button for a Remote TV.
Connecting the Receiver to the Phone Line
You must keep the receiver connected to an active telephone line.
Otherwise, you may not be able to order pay per view programs or use all of
the DISH Interactive features.
Note: You may be able to use a wireless telephone extender. However, this
may not support all the features of this receiver, such as Caller ID.
Note: If you have a Digital Subscriber Line (DSL), you may have to install
a DSL filter between the receiver’s back panel PHONE JACK and the
telephone wall jack to successfully connect with the DISH Network. You
can obtain a filter from your DSL provider.
Phone Line Connection
Run a telephone cable with a standard RJ-11 connector from the receiver’s
back panel Phone Jack to an active telephone connection.
Phone System Setup
You must also set up the receiver for your telephone system (touchtone or
rotary/pulse), and set a telephone number prefix, if you need a prefix to
make an outside call.
1. Display the
Phone System screen by pressing MENU-6-1-4.
Tip: The channel
stickers are located
inside the front
cover of this guide.