Filter
Top Products
Page 35
Setting Up TV1 to Operate in IR
c. Press the POUND (#) button. If you entered the address correctly,
the SAT mode button will flash three times.
d. Press the RECORD button.
e. Make sure the
System Information screen shows that the Primary
Remote Address
shows UHF Pro and IR and that this address
matches the number you entered in step b.
Setting Up TV1 to Operate in IR
The following instructions describe how to set up TV1 to operate in IR only.
1. Perform the following with an existing remote control:
a. Open the
TV1 UHF Pro Setup screen by pressing MENU-6-1-8 on
the remote control.
b. Select
Disable from the TV1 UHF Pro Setup screen.
c. Select
System Info to open the System Information screen.
2. Using an IR remote control, such as a Remote Control 3.0, that you
intend to use to control TV1:
a. Press the RECORD button. The
Done button should be
highlighted.
b. Make sure the
System Information screen shows that the Primary
Remote Address
shows IR.