Filter
Top Products
LC-XC1
20
TURNING
ON THE
PROJECTOR
1.
Complete the peripheral connections (with Computer, VCR, etc.) before turning on the projector. (Refer to
“CONNECTING TO THE PROJECTOR” on Pages 11-~14 for
connecting that equipment.)
2
Connect the projector’s AC Power Cord into a wall outlet and
turn the MAIN ON
I
OFF SWITCH to ON. The LAMP
indicator
lights RED, and the READY indicator lights GREEN.
3
Press the POWER ON-OFF button on the Remote Control
Unit or on the Top Control to ON. The LAMP
indicator dims,
and the
Cooling Fans start to operate. The Preparation
Display
appears on the screen and the count-down starts. The signal from the
source appears after 30 seconds.
TURNING OFF THE PROJECTOR
1.
Press the power ON-OFF button on the Remote Control Unit or on the Top Control, and the message “Power
off?” appears on the screen.
2
Press the power ON-OFF button again to turn off the projector.
The LAMP indicator lights bright and the READY indicator turns
off. After the projector is turned off, the Cooling Fans operate (for
about 90 seconds). During this “Cooling Down” period, this
appliance cannot be turned on.
3
When the projector has cooled down, the READY indicator
turns to green again and you can turn the projector on. After
cooling down completely, turn the MAIN ON
I
OFF SWITCH
to
OFF and
disconnect the AC power cord.
TO MAINTAIN
THE LIFE OF THE
LAMP, ONCE YOU
TURN THE PROJECTOR ON, WAIT AT LEAST 5
MINUTES BEFORE TURNING IT OFF.
When the Power Management function is ON, the
Projector detects the signal interruption and turns the Projection
Lamp off automatically. Refer to “Power Management” on page 33.
When WARNING TEMP. indicator flashes red, the projector is
automatically turned oft. Wait at least 5 minutes
before turning the projector on again.
When WARNING TEMP indicator continues to flash, follow procedures below:
1. Turn the MAIN ON
I
OFF SWITCH to OFF and disconnect the AC power cord from the AC outlet.
2. Check the air filters for dust accumulation.
3. Clean the Air Filter. (See “AIR FILTER CARE AND CLEANING” section on page 39.)
4. Turn the Projector on again.
If
WARNING TEMP indicator should still continue to flash, contact the sales dealer where you purchased this
projector or
service center.
NOTE:
The Cooling
Fan
may work for cooling while the projector is turned off. When the Cooling Fan is working,
WARNING TEMP. INDICATOR flashes red.