Filter
Top Products
LC-XC1
26
This Projector can automatically tune to the display signals from most personal computers currently
distributed. However, some computers employ special signal formats which are different from the standard
ones and may not be tuned by the Multi-Scan system of this projector.
If this happens, the projector cannot
reproduce a proper
image and the image may be recognized as a flickering picture, a non-synchronized
picture, a non-centered picture or a skewed picture.
This projector has a PC ADJUSTMENT function to enable you to precisely adjust several parameters to
match
with those special signal formats. This projector has
8 independent memory areas to memorize those
parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use
it.
Note : This PC ADJUSTMENT function cannot be operated when the input signal is from the COMPUTER INPUT-i
(DIGITAL) terminal or “RGB”
is selected on SYSTEM MENU (P24 and 25).
1
Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT RIGHT/LEFT button to select PC
ADJUST and press the SELECT button. Another dialog
box “Where to reserve” MENU will appear.
2
In this dialog box, you can store the parameter into the area from
“Mode 1” to “Mode 8.” When memorizing the new computer
parameter, select the Mode with the message “Free” by pressing
the POINT UP/DOWN button and the SELECT button. To
change the parameters of the Mode previously set, select the
Mode with “Stored.”
3
When the Mode is selected, Parameter adjustment dialog box
appears. Move the arrow to the item that you want to change by
pressing the POINT UP/DOWN button, and adjust each item by
pressing the SELECT button to match with your computer.
4
Move the arrow to “Stored” and press the SELECT button. The
parameter is memorized in the selected Mode.
5
To activate the Mode manually adjusted in this PC
ADJUSTMENT MENU, select the Mode at SYSTEM SELECT
MENU. (Refer to page 24.)