Filter
Top Products
LC-XC1
43
Problem:
Try these Solution
Remote Control Unit does not
work
Check the batteries.
Check the ALL-OFF switch on the Remote Control Unit is set to “ON.”.
Make sure nothing is between the Remote Receiver and the Remote
Control Unit.
Make sure you are not too far from the projector when using the
Remote Control Unit. Maximum operating range is 16.4’ (5m).
Make sure the code of the Remote Control is set to conform to the
projector. (See “SETTING” section on page 36, 37.)
Wireless Mouse function does
not work.
• Check the cable connection between the projector and the computer.
• Check the mouse setting on your computer.
• Turn the projector on before you turn on the computer.
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and electrical hazards.
WARNING:
High voltages are used
to operate
this
projector. Do not attempt to open
the
cabinet.
If the problem still persists after following all operating instructions, contact the sales dealer where you
purchased the projector or the service center. Give the model number and explain the difficulty. We
will advise
y
ou how to obtain service.