Filter
Top Products
LC-XC1
36
1.
Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT buttons to select
SETTING and press the SELECT button. Another dialog
box SETTING MENU will appear.
2
Press the POINT DOWN button and a red-arrow icon will
appear. Move the arrow to the item that you want to set, and then
press the SELECT button to set it “On” or “Off” or press the
POINT LEFT/RIGHT button to adjust the value.
Blue back
When this function is “On,” this projector will produce a blue image
instead of the video noise on the screen when the input
source
is
unplugged or turned off.
Display
This function decides whether to display the On-Screen Displays.
On1 shows all the On-Screen Displays.
0n2 shows the On-Screen Displays except the Preparation
Display (Our Logo).
Off
sets the On-Screen Displays disappeared except;
• •ON SCREEN MENU
• •Power off?” message
• •P-TIMER
Power management
This function
turns the Projection Lamp off when the projector detects signal interruption and the projector is
not used for a certain
period in order to reduce power consumption and maintain the Lamp-life. (This projector is
shipped with this function ON.)
Power Management function operates to turn the Projection Lamp off
when the input signal is interrupted and the projector is not operated
over 5 minutes. This function operates as follows;
1. When the signal is interrupted, “No signal” and the counting
down (5 minutes) display appears.
2. When the Projection Lamp turned off, the READY indicator
turns off. The Cooling Fans operate for 90 seconds after the
Projection Lamp is turned off. (During this “Cooling Down”
period, the Lamp cannot be turned on.)
3. When the Lamp has cooled down, the READY indicator flashes
and the Lamp can be turned on again (Power Management
mode).
In this Power Management mode, the Projection Lamp is
automatically turned on when the input signal connected or the
projector
is
operated with any button on the Top Control or the
Remote Control.
On start
When this function
is
“On,” the projector
is automatically turned on
just by switching the MAIN ON / OFF SWITCH on.
Note
;
Be sure to turn the projector off properly (refer to the section
“TURNING OFF THE PROJECTOR” on page 20.). If the projector
is
turned off in the wrong steps, the On Start function does not operate properly.