Filter
Top Products
74
VII. PAN/TILT ZOOM CONTROL
PTZ control is available for supported third-party dome cameras. The PTZ option must be
configured for each camera channel. For PTZ setup, refer to Camera Menu> PTZ setup.
The layout of the PTZ interface conforms to the layout of the front of the DVR or the remote
controller. Menu button is the guide anchor position for all other buttons. When in PTZ
interface mode, all buttons are used for the PTZ related operation.
1. P.T.Z. Menu
1) To activate the Pan/Tilt Control, select the full screen display of the camera you wish
to control.
2)
Then press the [P/T/Z/FOCUS] button. A shortcut Menu box pops up, as shown below.
INDICATOR ACTIONS
[ENTER]
[CANCEL]
Press this button to display “HELP” Menu. Press [ENTER] Button again, or
[CANCEL] button to cancel Help Menu.
Press this button to cancel “PAN/TITL” Operation.
[MENU] Button
PTZ camera control interface is extended to use all functions. Press this
button again to go to the short-cut menu.
To Tilt Up and Down.
To Pan Right and Left.
<Note > Please Refer to the Help Menu for specific