Filter
Top Products
-26-
Model G0747/G0748 (Mfg. Since 8/12)
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the
machine controls/components
discussed later
in this manual
are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and
seek additional training from expe
-
rienced
machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To complete a typical operation, the operator
does the following:
1. Examines the workpiece to make sure it is
suitable for milling.
2. Firmly clamps the workpiece to the table or a
mill vise.
3. Installs the correct cutting tool for the opera-
tion.
4. Uses the manual downfeed and table con-
trols to correctly position the cutting tool and
workpiece for the operation. If the X-axis
power feed will be used during the operation,
the operator confirms the speed and length of
table movement required.
5. Configures the mill for the correct spindle
speed of the operation.
6. Puts on personal protective gear, and makes
sure the workpiece and table are clear of all
tools, cords, and other items.
7. Starts the spindle rotation and performs the
operation.
8. Turns the mill OFF.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
this machine.