Filter
Top Products
Model G0747/G0748 (Mfg. Since 8/12)
-45-
Table Ways (One-Shot Oiler)
Oil Type ...... Model T23962 or ISO 68 Equivalent
Oil Amount ................... One Pull of Pump Handle
Check/Add Frequency ........4–8 hrs. of Operation
The one-shot oiler is connected to a series of alu-
minum tubes that carry the lubricant to wear points
along the table horizontal and vertical ways.
Pull the handle out slowly then release it to send
the oil through the tubes (see Figure 53), then
move the table through all paths of movement to
evenly distribute the lubricant.
Use the sight glass on the side of the oiler to know
when to re-fill the reservoir.
Figure 53. One-shot oiler.
Reservoir Cap
Sight Glass
Pump
Handle
Headstock Gearing
Grease Type ........................NLGI 2 or Equivalent
Grease Amount .........Two Pumps of Grease Gun
Check/Add Frequency ..........40 hrs. of Operation
Add two pumps from a grease gun to the grease
fittings that are shown in Figures 54–55.
Figure 54. Model G0747 headstock gearing
grease fitting.
G0747
Grease Fitting
Figure 55. Model G0748 headstock gearing
grease fitting.
G0748
Grease Fitting