Filter
Top Products
11
75 ohm extension to make your leads reach from the antenna to the VCR. This connection will
work only if you have a strong, clear picture on the TV, indicating a strong signal. Connect the
antenna to the adapter, and use the cable extension to go from the adapter to the VCR. Use the
supplied 75 ohm cable to connect the VCR to the TV.
Now continue with the hookup:
1. Using whichever adapter you have fit your antenna with, attach that connector to the IN
FROM ANT jack on the back of the VCR.
2. Using the 75 ohm cable supplied with your VCR, connect either end to the OUT TO TV jack
on the back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector back into the TV (where
you first disconnected the antenna).
Capabilities: With this hookup, you should now be able to perform all basic functions provided
by this equipment.
5 Attach the TV and VCR to the Power Supply
Plug in the TV and VCR power cords to the wall outlet or an appropriate extension cord or surge
protector. See Important Safeguards for further precautions (page 6).
6 Install Batteries in the Remote Control
The remote control requires two fresh "AA" batteries. On the back of the remote, a plastic cover
slides off in the direction shown by the arrow. Remove this cover and install the batteries,
matching the plus end of each battery with the plus mark on the remote.
7 Set the RF or Video Channel Switch
When the VCR is on, its video signal can come into your TV on either channel 3 or channel 4.