Filter
Top Products
59
Many operational problems are easily remedied by reviewing the instructions in this manual and
trying out some different controls and settings. The chart on page 79 covers the more common
problems that new VCR owners encounter.
Don't Attempt Repairs Yourself
Do not remove the cover or the back of the VCR – this will void the warranty and endanger your
safety. The exposed uninsulated voltage in this unit may be high enough to cause electrical
shock. It is dangerous to make contact with any inside part, and none of these parts are intended
to be serviced by an untrained user. To be safe, refer service problems to qualified service
personnel.
Technical Specifications
Format: VHS
Video Signal System: NTSC color EIA standard
Record/Playback System: Video: 4 Heads
Audio: VHS Hi-Fi stereo record/playback system
Tape Speed: 33.35 mm/sec (SP), 16.67 mm/sec (LP)(playback only),
11.12 mm/sec (EP)
RF Input: UHF/VHF 75 ohm
Tuner: USA: 181 channel tuning ability* (125 cable channels)
Type: Auto programming frequency synthesis
Power Input: AC120V 60Hz
Power Consumption: 22W nominal
Cabinet Size: 14-15/16" (W) x 3-11/16" (H) x 12-5/8" (D)
38.0 cm (W) x 9.3 cm (H) x 32.0 cm (D)
Weight: 9.9 lbs. (4.5 kg)
Storage Temperature: -4° F to 131° F
Operating Temperature: 41° F to 104° F
Accessories: 1 coaxial cable (Part No. 5861682),
1 remote control unit (Part No. HL10155), 2 AA batteries
* Check your cable company's compatibility requirements.
For more information about how to obtain these accessories, please call TOLL FREE 1-800-448-
2244 for your nearest Hitachi Authorized Parts Distributor in the continental United States. For
ALASKA and HAWAII, please contact the nearest Hitachi Regional office.
Design and specifications subject to change without notice.
Often Encountered Problems
Problem Things to Check Solution
No Power. Power cord plugged in? Connect the power cord to
AC outlet.
Delayed Program set to the correct Reset the delayed recording.
recording does channel? If using the VCR Plus+
system,
not work. check the channel setup.