HREP Color Digital Video Recorder User Guide
Document 800-06847 Rev B 39
08/10
Figure 2-21 PTZ Parameter Window
Configuring a PTZ Tour
You can configure a PTZ tour for each PTZ camera that is connected to the HREP. Before
you can con figure a PTZ tour, you must configure the presets. See Configuring PTZ Presets
in Live View on page 38.
1. Click TOUR on the PTZ SETUP menu (see Figure 2-18). The PTZ TOUR window
appears.
Figure 2-22 PTZ TOUR Window
2. Click next to MODE to select AUTO to enable PTZ Tour setup.
3. Click on the up/down arrows under the PRESET NO. column to select a preset (from
1 to 16), then click on the up/down arrows under the DWELL TIME to select a dwell
time (from 1 to 20 seconds).
Note Even though you can configure up to 255 presets using the PTZ menu, for
configuring a PTZ tour, you can select from only presets numbered 1 - 16.
4. Click OK to save the settings or click CANCEL to exit without saving.
Configuring the Camera Motion Sensor
Click MOTION SENSOR on the left side of the CAMERA menu. The Motion Sensor menu
appears.