Honeywell HRSD16 DVR User Manual


 
Installation
24
Your DVR can be used with either NTSC or PAL equipment.
Note You cannot mix NTSC and PAL equipment. For example, you
cannot use a PAL camera and an NTSC monitor.
Connecting the Video Source
Connect the coaxial cables from the video sources to the BNC Video In connectors.
Figure 2-2 Video Input Connectors
Connecting the Loop Through Video
If you would like to connect your video source to another device, you can use the Loop
BNC connectors.
Figure 2-3 Video Loop Through Connectors
Note The Loop BNC connectors are auto terminated. Do NOT connect
a cable to the Loop BNC unless it is connected to a terminated
device because it will cause poor quality video.
Table 2-1 Rear Panel Connections
# Connection # Connection
1 Video input 6 Network/Ethernet port
2 Looping connectors 7 RS485 port for remote devices
3 Audio input x2; audio output x1 8 Alarm inputs
4 Video main: BNC or VGA;
Spot-BNC
9 Alarm outputs
5 Serial RS-232C port 10 Power cord connector