Filter
Top Products
Installation
Document 800-00918 Rev F 29
02/08
Caution When you use the Factory Reset, you lose any settings you have
saved.
To reset the unit, you need a straightened paperclip:
1. Turn off the DVR.
2. Turn it on again.
3. While the DVR is initializing, the front panel LEDs blink. When the front panel LEDs
blink, poke the straightened paperclip to the unlabeled hole in the left of the Alarm
Output connectors.
4. Hold the switch until all the LEDs on the front panel are lit.
Note When the DVR successfully resets to factory defaults all the LEDs
on the front panel flash five times.
5. Release the reset switch. All of the DVR's settings are now at the original settings it
had when it left the factory.
Connecting the Power Cord
Caution In noisy electrical environments, use an Uninterruptible Power
Supply (UPS) to minimize the potential of damage to the DVR
from undesired power related hazards. Connect the UPS between
the DVR and the AC voltage supply.
Connect the AC power cord to the DVR and then to a wall outlet.
Figure 2-13 Power Cord Connector