Filter
Top Products
Masterpage:Left-FullCol
30 EN
Filename [HM-100U_Eng_05Index.fm]
PLAYBACK (cont.)
C Adjusting tracking condition
— Tracking Adjustments
Automatic tracking adjustment
This VCR automatically adjusts the tracking condition.
Whenever you insert a tape and start playback, automatic
tracking starts working and continuously analyzes the
signal to enable optimum picture quality during
playback.
Manual tracking adjustment
If automatic tracking cannot eliminate noises well during
playback, use the manual tracking following the
procedures below.
• You can also use the manual tracking during slow
motion playback (A page 34). During slow motion
playback, simply press [CHANNEL +] or [–] on the VCR
(or [TV/VCR CH +] or [–] on the Remote) to adjust
tracking.
1 Activate manual tracking
Press [CHANNEL +] and [–] on the front panel at
the same time during playback.
2 Eliminate the noises on the TV screen
Press [CHANNEL +] or [–].
•Press it briefly for a fine adjustment, or press and
hold for a coarse adjustment. Watch the screen
and continue adjustment until optimum picture
and sound quality are achieved.
•To reactivate automatic tracking, press
[CHANNEL +] and [–] on the front panel at the
same time. The automatic tracking becomes
active again.
D Selecting monitor sound
— Audio Monitor
You can select the desired monitor sound.
While playing back a tape on which stereo sound or SAP
sound is recorded, press [A. MONITOR] on the Remote.
Each time you press the button, sound changes as
follows:
S-VHS/VHS
D-VHS
NOTES:
• The above indication appears when “SUPERIMPOSE” is set to
“ON” (
A page 68), though the monitor sound changes in
sequence.
• If the tape being played back has no Hi-Fi sound track, the
normal sound track will be heard regardless of this setting.
“UL RV” : Normally select this.
Hi-Fi sound is played back.
“UL” : Sound on the left Hi-Fi channel is
played back.
“RV” : Sound on the right Hi-Fi channel is
played back.
“NORMAL” : Sound on the normal track is played
back.
“MIX” : Both sounds on the Hi-Fi track and
normal track are mixed and played
back.
“UL RV” : Normally select this.
“UL” : Sound on the left channel is played
back.
“RV” : Sound on the right channel is played
back.
NORMAL
MIX
L R
L R
L R
L
R
HM-DH100U_Eng.book Page 30 Thursday, August 5, 2004 1:54 PM