Filter
Top Products
Masterpage:Right-FullCol
EN 51
Filename [HM-100U_Eng_05Index.fm]
Electronic Program
Guide (EPG)
This VCR allows you to set recording timer or viewing timer by
selecting the program from the Electronic Program Guide (EPG).
NOTES:
• The EPG function works only when receiving digital programs.
• If the Easy Rec Timer or Easy View Timer is set for a program
whose start time has passed, a message “Check Start Time”
appears on the screen. In this case, exit the EPG screen and
perform manual recording.
A Easy Record Timer
1 Access EPG screen
Press [EPG].
•
The clock must be set to access the EPG screen. If you
have not set the clock, an error message will be
displayed. Refer to page 15 for the clock setting
procedure.
•
When the received channel is not a digital (DTV)
channel, “CAN NOT SET ON THIS CHANNEL SELECT
DTV CHANNEL THEN RETRY” appears on the screen.
•
When receiving digital broadcast, if [EPG] is pressed to
access the EPG screen at the same instant a blocked
program or scene is received, the EPG screen will not
be displayed.
In addition, if a blocked program or scene is received
while the EPG screen is being displayed, the sub
picture screen will turn black.
2 Select time zone and channel
3 Set record timer
4 Return to normal screen
Press [EPG].
5 Engage timer recording standby mode
Press [TIMER (j)].
The VCR turns off automatically and [j] is
displayed on the front display panel.
To use the VCR while it is in timer recording standby mode
Press [TIMER (j)] to cancel the timer recording standby
mode, then press [POWER] to turn on the VCR.
DO NOT forget to put the VCR into timer recording
standby mode again by pressing [TIMER (j)] after you use
the VCR; otherwise, you cannot record the broadcasts
you want.
• When “AUTO TIMER” (A page 68) is set to “ON”, the
timer recording standby mode is automatically engaged
when the VCR is turned off. It is temporarily canceled
when the VCR is turned on. You do not have to press
[TIMER (j)] to engage or disengage the timer recording
standby mode.
•Turn on the VCR and the TV, and select the AV
mode on the TV.
•Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
ATTENTION:
When setting recording timer of a digital (ATSC) program, the
VCR must be set to the standby mode condition 10 minutes
before the start time of a program.
As timer recording is performed based on the time
information of each program, timer standby and timer
recording may not be possible due to deviation in the timer
information of each program if the VCR is set to standby
mode within 10 minutes of the program start time. In such
cases, press [REC] to perform manual recording.
A-2,3
B-2,3
C-2,3
D-2,3
VCR
TV
CABLE
/DBS
[EPG]
Press [
D E
] to select the
desired time zone, and
[
FG
] to select the desired
channel, then press [OK].
•
The detail information of
the program will appear.
Press [D] to move the
arrow to “Easy Rec”,
then press [OK].
•The timer is set. An
mark appears in front
of the program title.
HM-DH100U_Eng.book Page 51 Thursday, August 5, 2004 1:54 PM