Filter
Top Products
Masterpage:Right-FullCol
EN 35
Filename [HM-100U_Eng_05Index.fm]
RECORDING
Basic Recording
NOTE:
When a new D-VHS tape is inserted, “AUT” is always selected
regardless of the previous recording speed selected.
This VCR can check the tape condition during recording
(and playback), and realizes the best possible pictures.
D-VHS Recording
A Load a D-VHS cassette
Make sure the record safety tab is intact. If not, cover the
hole with adhesive tape before inserting the cassette.
• The [D-VHS] indicator on the front display
panel lights up and the D-VHS recording mode
is enabled.
B Select recording channel
On the front panel:
Press [CHANNEL +] or [–].
On the Remote:
a– Press [TV/VCR CH +] or [–].
or
b– Press [DIGITAL CH], then follow by pressing
the ‘Number’ keys and/or [–].
• To access the sub channels of a digital channel,
you can make use of the [SUB CH +] and [SUB
CH –] buttons.
C Set recording speed
Press [REC SPEED] to set the recording speed.
• The recording speed changes each time [REC
SPEED] is pressed.
D Start recording
On the front panel:
Press [REC (R)].
On the Remote:
While holding [REC (R)], press [PLAY (I)].
•Turn on the VCR and the TV, and select the AV
mode on the TV.
•Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
IN F–1
A
[POWER]
[EJECT(M)]
[STOP(L)]
[REC SPEED]
[REC(R)]
B
[TV/VCR
CH+/ ]
[PLAY (I)]
[PAUSE (W)]
[STOP (L)]
[POWER]
[FF (N)]
[REC SPEED]
[ ]
[REW (O)]
[REC (R)]
[DIGITAL CH]
[SUB CH+]
[SUB CH ]
VCR
TV
CABLE
/DBS
‘Number‘ Keys
In addition, this VCR is equipped with the Video Navigation
function, which allows you to quickly locate the programs
you have recorded on a tape. When recording on this VCR,
the tapes are automatically numbered so that every tape
recorded on this VCR has a different tape number. With this
function, the program information such as recording date,
start time, channel number, and recording speed are also
automatically stored in the VCR’s memory.
• For the Video Navigation function, see page 53. To
memorize the recording date and start time for the Video
Navigation function, the date and clock must be set
correctly.
“AUT”:
(AUTO)
When recording in HS or STD mode
is selected automatically according
to the amount of data input (transfer
rate) of the program.
“HS”: When picture quality and sound
quality are important.
“STD”: When picture quality and recording
time are important.
“LS3”: To record for three times longer than
in STD mode, with picture quality
that is equal to or better than S-VHS.
HM-DH100U_Eng.book Page 35 Thursday, August 5, 2004 1:54 PM