Filter
Top Products
Masterpage:Left-FullCol
86 EN
Filename [HM-100U_Eng_05Index.fm]
MULTI-BRAND REMOTE CONTROL (cont.)
Changing
Remote Control
Code
NOTE:
When “POWER SAVE” is set to “ON”, you can not change the
remote control code. Before changing the code, set “POWER
SAVE” to “OFF” (
A page 69).
The Remote is capable of controlling four JVC video
recorders independently. Each of VCRs can respond to
one of four codes (A, B, C or D).
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily change your Remote and the VCR
to send and respond to B, C or D code signals.
When using four JVC VCRs, set the four VCRs and their
Remotes to different codes, so that the Remotes can
operate these VCRs separately.
A Set remote operation mode
Set the [VCR/TV/CABLE/DBS] selector to [VCR].
B Set remote control code for
Remote
A Press and hold [A/B/C/D].
B Press the ‘Number’ key [1] for A code control
signals, [2] for B code control signals, [3] for C
code control signals and [4] for D code con-
trol signals.
C Press [STOP (L)], and release [A/B/C/D].
C Turn off VCR
Press [POWER] on the VCR.
D
Check remote control code for VCR
Press [PLAY (I)] on the VCR for more than 5
seconds.
•The code currently set appears on the front
display panel.
E Turn on VCR
Press [POWER] on the Remote.
•The code transmitted from the Remote blinks for
a few seconds on the front display panel.
•After the code disappears on the front display
panel, make sure that the VCR is turned on by
pressing [POWER] on the Remote.
To control four VCRs with the same Remote
You can control four JVC VCRs by switching the remote
control code for the Remote between A,B, C and D as
in step
B , keeping four VCRs to different control codes.
•Press the ‘Number’ key [1] for A code control signals,
[2] for B code control signals, [3] for C code control
signals and [4] for D code control signals. (To change
only the remote control code for the Remote, DO NOT
perform steps
C to E.)
IN F–1
[PLAY( I)]
[POWER]
B - A,C
B - C
B - B
C E
VCR
TV
CABLE
/DBS
A
(E.g.) To set Remote to B code:
A/B/C/D
ABC
STOP
Hold
down
Press in succession
Release
HM-DH100U_Eng.book Page 86 Thursday, August 5, 2004 1:54 PM