Filter
Top Products
18 EN
Select cable box output channel
Your selection depends
on how your cable box
is connected to your
VCR.
● If your cable box is
connected to your
VCR’s ANTENNA IN
terminal on the rear
Press CH 5∞ on the front panel or %fi on the
Remote until the channel number representing
the cable box’s output (CH2 – CH9) appears on
the screen.
● If your cable box is connected to your VCR’s
AUDIO/VIDEO IN connectors on the front panel
Press CH 5∞ on the front panel or %fi on the
Remote until “ON F-1 (FRONT)” appears on
the screen.
● If your cable box is connected to your VCR’s
AUDIO/VIDEO IN connectors on the rear panel
Press CH 5∞ on the front panel or %fi on the
Remote until “ON L-1 (REAR)” appears on the
screen.
● If you do not use a cable box
Press CH 5∞ on the front panel or %fi on the
Remote until “OFF” appears on the screen.
Access Cable Box Brand Set screen
Press OK.
Enter cable box brand
On the Remote ONLY:
Press the appropriate
Number keys to enter
the brand code from the
list shown to the right,
then press OK.
● If the cable box’s
channel changes to 9,
setting is complete
Press OK and “CABLE
BOX CONTROL IS
ON” appears on the
screen for about 5
seconds, then it
returns to the normal screen.
● If the cable box’s channel does not change to 9
1 Press %fi (or CH 5∞ on the front panel) to
move the highlight bar (arrow) to “NO”.
2 Press OK.
3 Repeat step until the cable box’s channel
changes to 9 by entering another code.
4 If the channel does not change after going
through all the code numbers listed for your
model of cable box, then try all the other
numbers.
CABLE BOX BRAND SET
1
PRESS NUMBER KEY (0–9)
THEN (OK) TO TEST
PRESS (MENU) TO END
CABLE BOX BRAND SET
1
DID YOUR CABLE BOX
CHANGE TO CHANNEL 09?
= YES
NO
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END
123
456
7
89
0
VCR TV CABLE/DBS
INITIAL SETTINGS (cont.)
CABLE BOX SET
OFF
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END