Filter
Top Products
EN 23
BASIC PLAYBACK AND RECORDING
Basic
Playback
This VCR can check the tape condition during playback
(and recording), and realizes the best possible pictures.
● When you play back a tape recorded on this VCR, you
can use the Video Navigation function (੬ pg. 46).
Load a cassette
Make sure the window side is up, the rear label
side is facing you and the arrow on the front of
the cassette is pointing towards the VCR.
Do not apply too much pressure when inserting.
● The VCR turns on automatically.
● The counter is automatically reset to “0:00:00”.
● The tape will run for a few seconds while the
VCR searches for the tape number. If the tape
number is found, it will be shown on the TV
screen if “SUPERIMPOSE” is set to “ON.” (੬
pg. 56, 57)
● If the cassette’s record safety tab has been
removed, playback begins automatically.
Start playback
Press PLAY ( 3 ).
● Tape speed (SP or EP) is automatically detected.
● The S-VHS indicator lights up when you play
back a tape recorded in S-VHS mode or in S-
VHS ET mode (੬ pg. 31).
● If “VIDEO CALIBRATION” is set to “ON”
(default setting: ੬ pg. 57), “VIDEO
CALIBRATION” appears on the screen, and this
VCR checks the tape condition during
automatic tracking.
To stop playback
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7 / 0 )
on the front panel.
To rewind the tape (when it is not running)
Press REW ( 1 ) (or turn the TIME SCAN SHUTTLE
ring on the front panel to the left).
To fast-forward (when it is not running)
Press FF ( ¡ ) (or turn the TIME SCAN SHUTTLE ring
on the front panel to the right).
To eject the tape
Press STOP/EJECT ( 7 / 0 ) on the front panel when the
tape is not running.
● You can also eject the cassette when the VCR is turned
off.
To turn off the VCR
Press POWER.
NOTE:
When you use the Video Navigation function, operate the VCR
only after the tape number is detected; otherwise, you cannot
use the Video Navigation function.
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
123
456
7
89
0
VCR TV CABLE/DBS
STOP ( 7 )
FF ( ¡ )
REW ( 1 )
POWER
TIME SCAN
SHUTTLE ring
STOP/EJECT
( 7 / 0 )
POWER