Filter
Top Products
EN 21
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
INITIAL SET
CLOCK SET
LANGUAGE ENGLISH
GUIDE CHANNEL SET
CABLE BOX SET
=
DBS RECEIVER SET
JLIP ID NO. SET
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
DBS RECEIVER SET
OFF
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END
Access Main Menu screen on VCR
Press MENU.
Access Initial Set screen
On the front panel:
Press CH5∞ to move the highlight bar (arrow) to
“INITIAL SET”, then press OK.
On the Remote:
Press %fi to move the highlight bar (arrow) to
“INITIAL SET”, then press OK or
#
.
Access DBS Receiver Set screen
On the front panel:
Press CH5∞ to move
the highlight bar (arrow)
to “DBS RECEIVER
SET”, then press OK.
On the Remote:
Press %fi to move the
highlight bar (arrow) to
“DBS RECEIVER SET”, then press OK or
#
.
Select DBS receiver output channel
Your selection depends on how your DBS
receiver is connected to your VCR.
● If your DBS receiver
is connected to your
VCR’s ANTENNA IN
terminal on the rear
Press CH 5∞ on the
front panel or %fi on
the Remote until the
channel number
representing the DBS receiver’s output (CH3 or
CH4) appears on the screen.
● If your DBS receiver is connected to your VCR’s
AUDIO/VIDEO IN connectors on the front panel
Press CH 5∞ on the front panel or %fi on the
Remote until “ON F-1 (FRONT)” appears on
the screen.
● If your DBS receiver is connected to your VCR’s
AUDIO/VIDEO IN connectors on the rear panel
Press CH 5∞ on the front panel or %fi on the
Remote until “ON L-1 (REAR)” appears on the
screen.
● If you do not use a DBS receiver
Press CH 5∞ on the front panel or %fi on the
Remote until “OFF” appears on the screen.
CONTINUED ON NEXT PAGE \
Setting DBS receiver output
channel & brand
After installation, set the DBS receiver’s output channel
and its brand correctly; otherwise, the Controller cannot
work correctly.
Turn on DBS receiver
Select a channel other than channel 55, 100 or
205 on your DBS receiver.
–
123
456
7
89
0
VCR TV CABLE/DBS
–