Filter
Top Products
58 EN
* The default setting is bold in the table below.
When this function is set to “ON”, the VCR automatically switches to EP
mode to allow complete recording if there is not enough tape to record
the entire program while timer-recording in SP mode.
For Example . . .
Recording a program of 140 minutes in length onto a 120-minute tape
Make sure you set this function to “ON” before the timer-recording starts.
NOTES:
●
If you have programed the VCR to timer-record 2 or more programs, the second
program and those thereafter may not fit on the tape with this function set to
“ON”. In this case, do not use this function, but change the tape speed
manually during timer programing.
●
In order to ensure that the recording fits on the tape, this function may leave a
slight non-recorded portion at the end of the tape.
●
There may be some noise and sound disturbance where the tape speed switches
from SP to EP mode on the tape.
●
This function is not available during ITR (Instant Timer Recording), and will not
work properly on the following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and T(ST)-
120.
When this function is set to “ON”, edge correction to the luminance
signal is performed to enhance details. Normally set this function to
“ON”.
NOTES:
●
Depending on the type of tape being used, picture quality may be better with
“DIGITAL R3” set to “OFF”.
●
If you use this VCR as the playback VCR for editing, be sure to set “DIGITAL
R3” to “OFF” before starting.
When this function is set to “ON”, you can automatically correct vertical
vibrations in the picture when playing back unstable recordings made on
another VCR.
NOTES:
●
When you finish viewing a tape, be sure to set this function to “OFF”.
●
Regardless of the setting, this function has no effect during recording and during
special effects playback.
●
The on-screen display may jitter vertically when this function is set to “ON”.
●
To watch recordings with close-caption, set this function to “OFF”.
●
Video Stabilizer and Digital TBC/NR cannot be used at the same time. If you
activate Digital TBC/NR when “VIDEO STABILIZER” is set to “ON”, Video
Stabilizer will be automatically turned “OFF”.
When this function is set to “ON”;
● If a SAP program is received, the SAP audio is recorded on both the
normal and Hi-Fi tracks. The main audio is not recorded.
● If a non-SAP program is received, the main audio is recorded on both
the Hi-Fi and normal tracks.
When this function is set to “OFF”, the SAP audio cannot be recorded.
Ⅵ AUTO SP = EP TIMER
ON
OFF
Ⅵ VIDEO STABILIZER
ON
OFF
Approximately 110 minutes
SP mode
Approximately 30 minutes
EP mode
OTHER USEFUL FUNCTIONS (cont.)
Ⅵ 2ND AUDIO RECORD
ON
OFF
Ⅵ DIGITAL R3
ON
OFF
Refer to page 56 for setting procedures.