Accessories/Controls and Features (continued)
10
A [S-VIDEO] Input Terminal (4-pin mini DIN)
For input of S-video (Y/C) output signals of sources
such as video decks.
B [VIDEO] Input Terminal (BNC)
For input of composite video output signals of sources
such as video decks.
C
[Cr/Pr/R, Y/Gs, Cb/Pb/B, C-SYNC] Input Terminal
(Component/RGB input terminal BNC)
For input of 480i/480p, 576i/576p or 720p/1080i, 50
Hz/60 Hz signals.
● For output of the above signals upon converting to the
scan rate specified in the Setup menu.
D [PASS-THRU] Input Terminal
(Pass-through input terminal, D-sub 15 pin)
High scan rates for sources such as video signals of
HDTV or computers are passed through to the analog
outputs terminal. This processor is unable to project
signal input from this terminal using the projector.
● Input signals sent to this terminal are not converted or
transcoded (from YPrPb to RGBHV).
● Output to the [MONITOR] terminal is possible.
● Usually, this terminal is not used.
E [MONITOR] Output Terminal
(Monitor output terminal, D-sub 15 pin)
For use with computer monitors or to a second display
device.
● Usually, this terminal is not used.
● Set ASET: ACTIVE OUTPUTB of the Setup menu to
AANALOG RGB+DVIB or AANALOG RGBB.
(A Page 22)
● When HDCP signal input is sent to the DVI input
terminal, video signals will not be output from the
analog terminal. In this case, an AENCRYPTED
SOURCE ANALOG OUT DISABLEB message will
appear on the LCD.
● This cannot be used simultaneously with the DVI
output terminal.
● Use a D-sub cable within 3 m to prevent attenuated
and ringing signals. Also, make use of a 75K D15-BNC
conversion cable.
F [RED/Pr, GREEN/Y, BLUE/Pb, H/V SYNC]
Output Terminal (BNC)
For connection to a display device with an input
terminal for RGBHV or YPrPb signals.
● Usually, this terminal is not used.
● If computer signals are to be used, separate H & V
sync cables must be connected to the display.
● Set ASET: ACTIVE OUTPUTB of the Setup menu to a
value other than ADVIB. (A Page 22)
REAR
S-VIDEO
VIDEO Cr/Pr/R
ANALOGINPUTS ANALOGOUTPUTS
Y/Gs Cb/Pb/B C-SYNC RED/Pr GREEN/Y BLUE/Pb H SYNC V SYNC
IR LED
MONITORP ASS-THRU
AC INPUT
SCREEN
DVI INPUT
DVI OUTPUT RS-232OPTION RS-232CONTROL
JKLIHG
AB
CD
E
F
NM
LD-HD2KU_E.book Page 10 Thursday, November 17, 2005 4:27 PM