Filter
Top Products
Adjustments and Settings Using Menus (continued)
24
................................................................................................
.
SET: DVI INPUT H SYNC
(Horizontal sync signal setting during DVI input)
Sets when horizontal sync signals do not match.
● This setting is enabled when DVI input is selected.
................................................................................................
.
SET: OSD
(On-screen display setting)
Sets whether to display the OSD menu on the screen.
................................................................................................
.
SET: OSD TIMER
(OSD timer setting)
Sets the on-screen display time.
................................................................................................
.
SET: LCD TIMER
(LCD timer setting)
Sets the backlight of the LCD.
................................................................................................
.
SET: RS232 ECHO
(RS-232C echo setting)
Set to AONB when returning a RS-232C command from
this unit to an external control device. Please refer to 30
for details on RS-232C codes.
................................................................................................
.
SET: BAUD RATE
(RS-232C baud rate setting)
Sets the baud rate of RS-232C.
................................................................................................
.
SET: SCREEN TRIGGER
(Screen trigger setting)
Controls the screen trigger-compatible elevating screen.
Set this to AONB to output DC +12 V from the [SCREEN]
terminal when the power of this unit is on. No output when
this is set to AOFFB.
................................................................................................
.
SET: 1080i TO 1080p
(Output scan rate setting for 1080i signals)
Sets the mode of converting 1080i signals. This is
enabled only when the output scan rate is set to 1080i.
Select AHIGH BANDWIDTH MODEB to convert to a
maximum bandwidth without adjusting the picture image
(level, aspect ratio, etc.). Select AENHANCED MODEB for
a full image adjustment and minimum reduction in
bandwidth.
● This setting is enabled when the image output signal
(ASET: NTSC SCANRATEB or ASET: PAL SCANRATEB)
is set to A1920 ן 1080B or A1920 ן 1080/50HzB.
................................................................................................
.
SET: NTSC PROFILE
(Profile setting for NTSC signals)
Stores all setting values of the NTSC signal to the
selected profile number.
................................................................................................
.
SET: PAL PROFILE
(Profile setting for PAL signals)
Stores all setting values of the PAL signal to the selected
profile number.
................................................................................................
.
SET: RESTORE FACTORY
(Default setting)
Restores to the factory settings.
● Performing this setting clears all profiles and setting
values.
● Use this command when this unit is unable to function
properly at all, or after all system checks have been
completed.
● Before using this command, unplug the power plug of this
unit. Alternatively, press the reset switch at the front of this
unit (inside the hole) lightly using a non-pointed, stiff thin
rod. This will reset the software without clearing the
settings.
Setting Values: NORMAL, WIDE
Default Value: NORMAL
Setting Values: ON, OFF
Default Value: ON
Setting Values: 0-255
Default Value: 30
Setting Values: ALWAYS ON, 06-255
Default Value: 30
Setting Values: ON, OFF
Default Value: ON
Setting Values: 9600, 19200, 57600
Default Value: 19200
Setting Values: ON, OFF
Default Value: ON
Setting Values:
HIGH BANDWIDTH MODE, ENHANCED MODE
Default Value: HIGH BANDWIDTH MODE
Setting Values: STORE PROFILE 1-8
Default Value: STORE PROFILE 1
Setting Values: STORE PROFILE 1-8
Default Value: STORE PROFILE 1
LD-HD2KU_E.book Page 24 Thursday, November 17, 2005 4:27 PM