Filter
Top Products
Command of the remote control
Command of the remote control
The remote control features 2 command sets, making it possible to operate
2 receivers independently of each other in one room (not together with a twin
receiver).
Note For this purpose, program one receiver on the command set 1 and the second
receiver on the command set 2.
· Switch on receiver 1 and receiver 2 off with the power switch
Þ Press and hold the
Abutton.
Þ Enter "901" with the number buttons.
· To adopt the code, press the
ebutton to switch receiver 1 to standby and
then switch off the device with the power switch.
· Switch on receiver 2.
Þ Press and hold the
Abutton.
Þ Enter "902" with the number buttons.
· To adopt the code, press the ebutton to switch receiver 2 to standby and
then back into operation. Now switch on receiver 1 again.
Þ Press and hold the
Abutton.
Þ Enter "903" with the number buttons.
Note When carrying out the first two settings, the remote control must be directed at the
respective receiver (when switched on).
By pressing the
Abutton, you can now switch between the two command sets A
and B (toggle function) and alternately operate both receivers.
Command set 1 is always active as the on-delivery setting.
Note If you are operating only one receiver and the active command set is switched over
by mistake so that this receiver can no longer be operated, the remote control can
be easily switched back to command set 1. For this purpose, follow the procedure
described above.
11