Filter
Top Products
Timer settings
Timer settings
You can use the timer for recording a programme with a video recorder on time.
Seven timers are available which you can set to different programmes as well as
start and end times.
To access the timer setting, press
Mto
enter the main programme menu,
uoto go to system parameters,
followed by
Oand uo to local
time / timer and
O. The screen shown
in the margin appears.
Press the
oubuttons to move the
cursor to the desired timer and confirm it by pressing
O. Press Lto exit the
timer again.
Incorrect time settings will be rejected.
You can select and set
· the programme type (TV, radio or software download)
· the programme location (numerical via the remote control),
· the start time (date, month, year, hour, minute)
· the stop time and
· the timer status (inactive/once/daily/weekly)
for seven timers. You must
enter leading zeros for the time settings.
You can also carry out the pre-programming via the EPG (Electronic Program
Guide). Refer to section „Programme overview – Full EPG."
Use the
- or + and the number buttons to make the required setting.
The current time that you must re-enter appears under the start time. If no other
setting is entered, the end time will be set automatically to the same date and one
hour after the start time.
Finally confirm the settings by pressing
M or L 3 times.
If you have preset a download per timer, the following timer settings are ig-
nored after a successful download!
VPS signal
Make certain, that no VPS signal is included in the digital television signal.
Therefore, you will need to programme your video recorder corresponding to the
timer settings.
23