Filter
Top Products
Installation menu
Tone Burst
Under this menu point, the 22 kHz signal can be set as follows:
: Switching statuses of setting Switching statuses of setting:
22-kHz Signal —> High/Low
and
Tone Burst —> Pos. A/B:
22-kHz Signal —> Pos. A/B
and
Tone Burst —> Opt. A/B
22-kHz Signal —> Pos. A/B
and
Tone Burst —> High/Low
Low
High
22-kHz
22-kHz
Off
On
Pos Tone Burst 22-kHz Low
High
Tone Burst
Tone Burst
0
1
Pos. 1
Pos. 2
Tone Burst
Tone Burst
0
1
0
0
1
1
Off
On
Off
On
Pos. 1
Pos. 2
22-kHz
22-kHz
Off
On
DiSEqC
If the receiver is connected to a DiSEqC switching matrix, you will need to set this
menu point to ON.
The switching criteria and the input assignments of the DiSEqC switching matrix
must be maintained. Therefore, refer to the description of the switching matrices or
contact the installer of the receiving system.
DiSEqC Repeat
The DiSEqC command must be repeated if the receiver is operated (cascaded) to-
gether with a receiving system with two or more series connected DiSEqC switch-
ing matrices.
In this case, switch the menu point "DiSEqC repeat" to 1 or 2.
Factory preset: OFF
UFO mini
The input frequency of the receiver is fixed in a "user-controlled processing sys-
tem". The signals from the "user-controlled processing system" are transmitted on
this frequency. The reception parameters for programme selection are transferred
to the receiving system by means of a DiSEqC command and set accordingly.
The relevant setting that needs to be selected depends on the type of "user- con-
trolled processing system".
The setting should be made according to the data provided in the installation
instructions for the "user-controlled processing system".
Remote frequency
If you have set the UFO mini menu point to ON, you will need to set the transmis-
sion frequency under this menu point.
Refer to the installation instructions of the "user-controlled processing system" for
the set transmission frequency.
It is therefore important that you refer to the information provided in the installation
instructions of the "user-controlled processing system".
UFO micro
The setting under this menu point is also designed for operation of the receiver to-
gether with a processing system.
Control and communication between the receiver and the Kathrein UFO micro sys-
tem takes place on the return of the coaxial cable.
ON must be set under the UFO micro menu point if the receiver is operated
together with a UFO micro receiving system.
During installation, the receiving system then assigns a special address to the re-
ceiver so that the control instructions that are sent from the receiver to the receiv-
ing system for signal selection are also recognised by this system.
43