Filter
Top Products
First time installation
First time installation
The first steps
Connect the receiver to the mains power supply.
Switch on the receiver by pressing the power button at the front of the unit.
You will see "- - - -“ in the LED display, afterwards "0000."
The operation indicator LED lights up red, the receiver is now in standby mode.
Switch on your TV set.
Switch on the receiver by pressing the
ebutton on the remote control.
The yellow LED at the front end of the receiver flashes every time a button on the
remote control is pressed.
You will see the factory preset programme on your TV screen. An information bar
indicating the programme provider, the time, the timer settings, the programme
status and the programme title will be displayed in the bottom section of the screen
provided the corresponding data are transmitted. The number of the programme
memory appears in the LED display.
The red standby indicator extinguishes.
You can now receive the TV and radio programme preset at the factory and select
them by pressing the
ou buttons. Press the Rand oubuttons to
select radio programmes. Press the
Ror Tbutton to return to TV programmes.
Refer to the section " Programme lists – TV/radio" for information on how to set up
and save other TV and radio programmes.
The reception status last set always reappears when the receiver is switched on.
If the message "bad or no signal" appears on the screen in addition to an on-
screen display indicating the programme last received, you will need to check the
system installation and/or the receiver settings. If this problem only applies to indi-
vidual programme slots, the problem may be due to an interruption in the transmis-
sion signal or a fault in the receiving system (cable or satellite system).
In this case, first check the connection configuration and then check whether the
basic settings of you receiver are correct for your system. In the case of doubt,
have a specialist do this for you.
Factory setting of receiver
Your receiver is pre-programmed to receive the ASTRA and HotBird satellites. You
will normally need to make no further settings. To receive both satellite systems or
other satellites you will require a multifeed arrangement with at least two LNBs in
front of the satellite dish if you are not connected to a communal or party system.
Please ask your provider.
Before you change the basic settings of your receiver, note down the settings in
the form provided at the end of this User's Guide. In doing so, you will be able to
restore the original settings at any time.
16