Filter
Top Products
Installation Menu
72
Installation Menu
You should not change the following settings without a good reason,
as they are factory settings or operating settings that are tailored to
your reception system.
New settings are only required if the reception system is changed or
expanded.
Select the “Installation” menu with the
button, the
buttons in
the main menu and
. If a password has been stored, you must
enter it. Use the
buttons to select the further items.
LNB Configuration
The first submenu is the “LNB Configuration”. Press
to open it.
You should not normally make any changes in this submenu.
Before making any changes, however, you should make a note of the
settings in the form provided at the end of this manual. Your receiver
is preset at the factory to the satellites of the ASTRA and HOTBIRD
systems.
The other basic settings are shown in the screenshot above.
Oscillator Frequency L.O.
Satellite reception systems consist of a parabolic antenna attached to
the actual reception system (LNB - Low Noise Blockconverter or
LNC - Low Noise Converter), which converts the RF signal from the
satellite into a lower frequency that can be processed by a satellite
receiver.
The satellite transmission frequencies are located in the following
ranges:
10.7-11.7 GHz Low band
11.7-12.75 GHz High band
Pay attention to the
bar at the bottom of
the on-screen display!
It provides guidance
on what to do next.