Filter
Top Products
Video Recorder Connection
83
Video Recorder Connection
For details of how to connect your video recorder to the receiver refer
to the connection diagram provided at the end of this manual and the
instructions for the video recorder.
Recording
In order to make a VCR recording (Record), the satellite receiver must
be switched on or the timers must be pre-programmed (see “Timer
Settings” section).
Playback
For VCR playback (Play), the satellite receiver must be set to
“standby”, so that the signal path is switched through from the
VCR/AUX Scart socket to the TV Scart socket.
You must set the Scart socket of the Sat receiver to “AUX” with
the
button in order for your TV set to automatically play back the
picture from the video recorder.
In this setting, the picture from the video recorder is switched through
to the TV set during playback.
If you set “SAT” by pressing the
button, the Sat receiver will have
priority.
In the “TV” setting, the video signal of the TV set has priority. TV mode
is indicated by the green LED on the front panel.
Note: For system reasons the TV and VCR Scart sockets carry the same
signal.