Filter
Top Products
Installation Menu
82
UFO
®
micro
The setting for this menu option is also designed for operation of the
receiver in a processing system.
The return path of the coaxial cable is used for control and
communication between the receiver and the Kathrein UFO
®
micro
system. If the receiver is operated in a UFO
®
micro reception system,
the “UFO
®
micro” menu option must be set to “On”.
The reception system then assigns the receiver a special address
upon installation, so that it will recognise the control commands sent
by the receiver to the reception system for signal selection.
In this operating mode, a remote frequency does not need to be set,
as it is specified by the UFO
®
micro system with the addressing.
If the receiver is being used in a UFO
®
micro reception system for the
first time, the address previously assigned must be deleted. This is
done under the “UFO
®
micro” menu option by selecting “Reset” with
the
buttons and confirming with
.
The receiver is then assigned the original factory setting. It then needs
to be set to “On” again. The receiver receives its new address from
the new system.
“Reset” does not delete the pre-programming.
Default setting: “Off”.
Factory Set
Under this menu item, you can reset all the settings to their factory
defaults by pressing
.
The factory settings do not necessarily correspond to the settings
required for your specific system.
You may need to re-enter all the settings following the reset.
Note down the settings on the service page provided at the end of this
manual!
Logging on to UFOmicro
®
Procedure (see page 10)
Important: The receiver must
not be connected to the
antenna socket outlet prior
to logging on!