Filter
Top Products
Creating a Macro
25
Figure 34: Switcher RC Command
5.2.4 A Power Amplifier Command
To write a power amplifier command
1
on an RC button, do the following:
1. Select the POWER_AMP Port.
2. In the RC command area, write the command description (for example, High
Volume).
3. Select the power amplifier command (for example, Volume set).
4. Move the sliding switch to the desired volume (for example, 12dB).
Figure 34 illustrates the RC Command area as it appears after writing the
command:
Figure 35: High Volume RC Command
1 For the Master-Slave configuration only