Filter
Top Products
Writing a Configuration
37
6. Select Use the following IP Address, and fill in the details as shown in
Figure 54.
7. Click OK.
Figure 54: Internet Protocol (TCP/IP) Properties Window
8.2 Connecting the ETHERNET Port via a Network Hub (Straight-
Through Cable)
You can connect the Ethernet port of the RC device to the Ethernet port on a
network hub or network router, via a straight-through cable with RJ-45
connectors.
9 Writing a Configuration
Once your configuration is ready, you can write it to the device, via the “Write
Configuration” button.
Note that if the room controller is defined as a:
Master (stand alone), the configuration is written directly to the device
Slave device (the room controller is connected to the SV-551), the
configuration is written to the SV-551
In case you have written the configuration to a stand alone device and it is
now connected as a slave to the SV-551, you have to write the configuration
once again after defining the device as a slave.