Filter
Top Products
Operation
RGB (PC) mode only; This function doesn't work for RGB-DTV mode.
Automatically adjusts picture position and minimizes image shaking.
After adjustment, if the image is sti@Inot correct, your Monitor is functioning proper_y but ne_s further adjustment
The Auto conflg,, Position and Manu_ conflg_ are not active in DV[ mede_
1_ Press the MENU button and then use A / V button to select the SCREEN menu
2. Press the I1_button and then use A / V button to select Auto _g=.
3. Press the I_ button to run Auto configure.
° When Auto ¢e_g, has finished OK will be shown on screen
* if the position of the image is still not correct, try Auto adjustment again.
4_ h RG8 (PC) mo_, ff the image needs to be adiusted _re after using Auto
¢o_rlUg., you can make further adjus_ents with the Mer._u_ ¢e_ltg. option.
Caution: If a 4:3 fixed image is on the screen for a {ong time, it may remain visible.
Set every aspect ratio for Monitor, Video, Component 480i sources.
Use 4:3, or 16:9 for other RGB-PC and DVt-PC sources.
Horizon is not available for Component (480p,720p,1080i), DTV (480p,720p,,1080i) sources.
1. Press the ARC button relatedly to select the desired picture format. You _n aJso adjust ARC in the SCaN menu.
'*4:3
Choose 4:3 when you want to view a picture with an origina_ 4:3 aspect ratio, with btack bars appearing at both the
left and right sides.
.16_9
Choose 16,'9 when you want to adjust the picture horizontally, ina linear proportion to fi[[ the entire screen.
* Horizon
Choose Horizon when you want to adjust the picture in a non linear proportion, that is more enlarged at both sides,
to create a spectacular view.
- Ch_se Zee_ when you w_t to view the picture without _y alteratiom However, the top and bottom portions of the
picture wi_ be cropped
- This function works in the following modes:
RGS_PC, RGB_D_/(480p,720p,1080i), DW_DTV (480p,720p,1080i), COM-
PONENT (4.80p,720p,1080i),
1. Press the MENU button and then use A IV button to se}ect the SCR_ menu,
2. Press the I_ button and then use A _V batten to setect Position.
3. Press the I_ button and then use A /V _4/1_ button to adjust the position
4 Press the OK button to save.
24 Plasma Monitor