Filter
Top Products
ExternalControlDeviceSetup
External Control Device Setup
Connect the RS 232C input jack to an externa_ control device (such as a computer or an AN control system)
and control the Monitor's functions externafiy.
Connect the sedal port of the control device to the RS-232C jack on the Monitor back panel
RS-232C connection cables are not supplied with the Monitor.
@@@ @@ @@@
@@@ @@ @@@
PC
No. Pin name
1 No connection
2 RXD (Receive data)
3 TXD (Transmit data)
4 DTR (DTE si_ ready)
5 GND
6 DSR (DCE side ready)
7 RTS (Ready to send)
8 CTS (Clear to send)
9 No Connection
...............................................................................................1
9
6
RXD
TXD
GND
DTR
DSR
RTS
CTS
7-Wire Configurations
(Standard RS-232C cable)
PC
iiiiiiiii
iiiiiiiii ...........................................................................
iiiiiiiii
iiiiiiiii_
iiiiiiiiii
3-Wire Configuration s
(Not standard)
D-Sub 9
PDP PC PDP
TXD RXD ..............................................................................!ii!ii!i!i!!i_iiiiiiiiii!;iiii31_ii_ii_ii_ii_ii_ii_ii_ii!iii_!!I TXD
RXD TXD iiiiiiiiiiiiiiiiiiiiiiii31_i_i_i_;!;!:i:i:i:i:_ RXD
GND GND iiiiiiiiiiiiiiiiiiiiii!,_S:_:iiii!:i!:i!:ii'ililili GND
iiii6!_i_i_i!_i!_i!_i!_i!_iii:ili!lDSR DTR DTR
DTR DSR DSR
CTS RTS RTS
..... RTS CTS !i_!i_!i_!i!i!_izii!!i!!81_i_ii_ii_ii_ii_ii_iiiii_!illCTS
D-Sub 9 D-Sub 9 D-Sub 9
28 Plasma Monitor