Filter
Top Products
92
Setting up Remote Viewing - Appendix #14
Setting up Remote Viewing - Appendix #14
Setting up the Remote Viewing Feature requires several steps. Networking skills are required to
correctly configure the remote viewing functions.
What do you need?
• The 19” System.
• A PC with the installed NetViewer software (refer to the NetViewer Guide for installation
instructions)
• A Router (not provided with the system) and High Speed Cable or DSL Internet Connectivity
(for remote viewing outside your network)
Network Setup / Remote Access Overview
The SG19LD804-161 Observation System can be remotely controlled using your existing network
and the Lorex NetViewer software.
1. Connect the Observation System to the Router using the supplied Ethernet Cable. Power the
Observation System on. The Observation System must be connected to the router prior to
powering on the system. This allows the system to communicate on your network
2. Find the IP address of your Observation System through the Menu System on the unit.
3. Set up a web account at http://DDNS.strategicvista.net
.
4. Enable PORT FORWARDING on your Router. Refer to the included Router Guide and Basics
of Remote Video Access Guide for further assistance with your specific network setup and
hardware.
5. Setup the Observation System DDNS.
6. Configure the software, using the information gathered on the following pages.
OBSERVATION SYSTEM
ROUTER
(Not Included)
PC
(Not Included)
INTERNET