Filter
Top Products
80
PROBLEM SOLUTION
Other disc errors (DVD+R),
'Disc contains unknown
data'
bThis message may appear if you insert a disc that was not finalized. DVD+R's that have not
been finalized are very sensitive to fingerprints, dust, or dirt. This may cause problems during
recording.
To use the disc again, follow the next steps.
1 Make sure the surface of the disc is clean.
2 Open the disc tray with OPEN/CLOSE J . Insert the DVD+R but do not close
the tray.
3 Hold down 5 on the remote control until the tray closes. The disc will be read
('READING' appears on the display) and the DVD recorder will start the repair
process. This may take up to four times as much time as the recording, in which the
error occurred.
4 If the disc is recovered, the index screen will appear.
Please observe the following:
Error during recording: The title may be missing.
Error while changing the title/index picture: The original title/index picture may be visible.
Error while finalizing: The disc appears not to have been finalized.
The index screen flickers
when a DVD+R is inserted
bYou can finalize the disc using the following function:
1 Open the disc tray with OPEN/CLOSE J . Insert the defect DVD+R but do not
close the tray.
2 Hold down 4 on the remote control until the tray closes.
'FINALIZE' appears in the display. Finalizing begins. This may take up to three
minutes.
3 If finalizing has been successful, the index screen will appear.