Filter
Top Products
54
ENGLISH
No sound from the DIGITAL OUT (optical or coaxial)
jacks.
The [Digital Out] menu is set to [Off].
Set the [Digital Out] (Audio 1 menu) to [On] (page 25).
Audio is not output or is distorted.
The Setup screen Audio 1 menu [96 kHz PCM Out]
setting is set to [96 kHz]. Digital output is prohibited on
some discs.
\ Be sure to make analog audio connections as well as
digital connections (page 13).
The disc is dirty.
\ Refer to
‘Disc Care’
(page 48).
The connection plugs are not inserted fully into the
terminals or are not connected.
\ Check that all connection plugs are firmly inserted.
The connection plug or terminal is dirty.
\ Check that the plugs and terminals are wiped clean of
dirt, etc.
Audio cable connection is wrong.
\ Check to make sure that the audio cables are
connected correctly (page 13).
Connection is made to the stereo amplifier‘s PHONO input
terminal.
\ Change connection to any input terminal except
PHONO.
The pause mode is engaged.
\ Press PLAY 3 to exit the pause mode.
Stereo amplifier operation is incorrect.
\ Check input (CD, AUX, etc.) selector to determine if it
is selected for DVD playback.
The DVD or CD is recorded in DTS audio.
\ DTS audio is only output from the digital output jacks.
Connect the digital output on the player to the digital
input on a receiver or amplifier with a built in DTS
decoder to hear DTS audio.
Noticeable difference in DVD and CD volume.
DVDs and CDs use different recording methods.
\ This is not a malfunction.
Caution
Static electricity or other external influence may cause
malfunctioning of this unit. In this case, unplugging the
power cord and then re-plugging it in will usually reset the
unit for proper operation. If this does not correct the
problem, please consult your nearest MARANTZ service
center.