Filter
Top Products
69
Connection of external devices with YUV compo-
nent output to the "COMPONENT IN" RCA jacks.
The signal type always refers to the input
and output of the AV device.
AV devices equipped with a YUV jack can be con-
nected to the LCD TV by means of a YUV cable
(see page 81). In the "AV Devices" menu, the con-
nected AV device must be registered with signal
OUT "YUV" or "YUV (HD)".
The connection of the analogue YUV source using
the RCA jacks to the YUV input of the LCD TV
depends on the output format of the signal source.
Configure the following settings, depending on the
output format of your signal source:
Signal type
Source format
YUV 576i
YUV (HD) 576p, 720p, 1080i
Setting the YUV or YUV (HD) Signal Type
- Enter the TV menu by pressing
"MENU".
- Press the yellow key to open the "AV
Devices" menu.
- Use the cursor control to select the AV
device whose signal type you want to
change and press "OK".
- Press numeric key
·, use the cursor
control to select "Signal OUT", and use the - +
key to set "YUV" or "YUV (HD)".
- Confirm the setting by pressing "OK".
- Exit the "TV Menu" by pressing "EXIT".
Caution ! This may cause an existing con-
nection diagram to be modified. If so, you
must reconnect the AV devices accordingly.
☞
☞
MENU
Other device 3
Other device 2
Other device 1
PC
Satellit / set top
DVD Player 2
DVD Player 1
DVD/Videorec.3
DVD/Videorec.2
DVD/Videorec.1
Signal OUT YUV(HD) Signal IN CVBS
Change with
Accept value with
OK
OK
ᕢ
OK
EXIT
Opening the menu
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
– +
F1
➔
DataLogic
Activate TV-SPDIF-inp
Name
Signal types
Connect
✗
✗
25. Registering AV Devices
Setting signal types YUV/YUV(HD)
605 47 2029.A2 LCD-GB 10.03.2006 8:53 Uhr Seite 69