Filter
Top Products
8 - 4 8 - 4
MELSEC-Q
8 PROGRAMMING
(b) Auto refresh settings (see Section 7.5)
Set the values as shown in the window below. (Use channel 1.)
Setting item Description Setting
CH1 Present value Set the device for storing the present value. D0
CH1 Latch count value Set the device for storing the latch count value. D2
CH1 Sampling count value
Set the device for storing the sampling count value when the
sampling counter function is used.
D4
CH1 Periodic PLS counter previous value
Set the device for storing the previous periodic pulse count
value when the periodic pulse counter function is used.
D6
CH1 Periodic PLS counter present value
Set the device for storing the present periodic pulse count
value when the periodic pulse counter function is used.
D8
CH1 Sampling/periodic counter flag This is not used. —
CH1 Overflow detection flag
Set the device for storing the overflow detection result when
the linear counter function is used.
D10
(c) Writing the intelligent module parameters (see Section 7.3.3)
Write the intelligent module parameters to the CPU module. This operation
is performed using the intelligent module parameter setting module
selection window.